Ready-made, white, special industrial mortar, cement base, based on white cement Portland high strength (I-52.5), reinforced with polymer components inert selected granulometry, fibres and special additives for adhesion to Surfaces of thermal insulating plates.
Uses
It Is used for the coating of thermal insulating plates of expanded or extruded polystyrene and rockwool, for the reinforcement of these surfaces in combination with suitable fiberglass mesh MARMOLINE, in external and internal surfaces of buildings . It Is also used as bonding adhesive of thermal insulating plates on surfaces such as concrete, bricks, plaster, cement stones, concrete, stone, etc. in external and internal facades of buildings. It Is part of the certified external thermal insulation system (ETICS) MARMOLINE MONOSIS.
Advantages
Excellent adhesion on the surfaces of thermal insulating plates.
High mechanical strengths.
Elasticity.
Great resistance to time.
High resistance to temperature changes of heat and cold.
Ease of application (add only water).
How to Apply
Check the substrate so that it is clean from loose materials, powders, etc.
Mix well, with a low-speed electric drill, a 25 kg sack with about 6 liters of clean water, until a homogeneous sticky mass without lumps is achieved. Allow the mixture for 5-10 minutes to mature and stir again for a while.
As glue, apply the FK 202 to the entire surface of the insulating plate, 2 – 3 mm in thickness, with a serrated spatula or with the help of an automatic press, or around the plate and then at selective points in the centre, as long as the adhesive is covered At least 40% of the insulating surface.
The placement of thermal insulating plates should be done starting from the bottom of the masonry upwards, crosswise without gaps.
As reinforced Mortar, apply the material with a serrated spatula in a layer thickness of 2-3 mm. In this layer, place suitable fiberglass mesh and with the help of smooth spatula immerse it in it. The mesh strips should overlap by approximately 10 cm. At the end, the surface is grinding while removing the unnecessary mortar.
The time of use of the ready mix is 2-4 hours, depending on the temperature of the environment and the season.
Specifications
-European Directive ETAG 004 for ETICS Systems: Component part of the system MARMOLINE MONOSIS ENERGY SAVING SYSTEMS ETΙCE, approved/certified with the use of insulated polystyrene plates EPS (RTD 17/0100), and with the use of XPS (RTD 14/0214) and MW stone wool (RTD 14/0213) plates.
FK 202 25KG
13,70 € With VAT
WHITE WASHABLE COATING FOR EXTERNAL HEAT INSULATION
In stock
SKU: 10.027.029
Category: Facade
Weight | 25 kg |
---|
Related products
-35%
-35%
-25%
-30%
-33%
-35%
-32%
-35%